Engine Control System (2GR-FE) (Service Information): ECM: Removal: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
WARNING:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE AIR CLEANER CAP . Refer to REMOVAL - Step 19
REMOVE AIR CLEANER CASE . Refer to REMOVAL - Step 20
REMOVE ECM
1. Remove the 3 bolts of the ECM bracket.
  
  Fig 1: Identifying ECM Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the 2 ECM connectors.
  
  Fig 2: Identifying ECM Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  After disconnecting the connector, make sure that dirt, water and other foreign matter does not contact the connecting part of the connector.
  1. Raise the 2 levers while pushing the locks on the 2 levers, and disconnect the 2 ECM connectors.
3. Remove the ECM with bracket.
4. Remove the 4 screws and 2 ECM brackets.
  
  Fig 3: Identifying ECM Brackets Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002