4WD Control Switch: Inspection: Inspection

INSPECT TRANSFER POSITION SWITCH (4WD CONTROL SWITCH)

Measure the resistance according to the value(s) in the table below.

Fig 1: Identifying Transfer Position Switch Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard Resistance

Tester Connection	Switch Condition	Specified Condition
2 (2WD) - 4 (GND2)	H4 Position	100 kΩ or higher
2 (2WD) - 4 (GND2)	L4 Position	Below 1 Ω

If the result is not as specified, replace the transfer position switch.