LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2011 >> Yaris 2D Hatchback, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System (Service Information) >> Rear Speed Sensor >> Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Speed Sensor: Installation: Installation

  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY  . Refer to INSTALLATION - Step 1
  2. INSPECT REAR AXLE HUB BEARING  . Refer to ON-VEHICLE INSPECTION - Step 10
  3. CONNECT SKID CONTROL SENSOR WIRE  . Refer to INSTALLATION - Step 3
  4. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY 
  5. ADJUST REAR DRUM BRAKE SHOE CLEARANCE  . Refer to INSTALLATION - Step 2
  6. INSTALL REAR WHEEL 

    Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

  8. CHECK VSC SENSOR SIGNAL (w/ VSC) 

    Refer to TEST MODE PROCEDURE

  9. CHECK ABS SENSOR SIGNAL (w/o VSC) 

    Refer to TEST MODE PROCEDURE

scientia non olet · About LEMON Manuals