Front Speed Sensor: Installation: Installation

WARNING: This page is about a different car, the 2013 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT SPEED SENSOR
1. Install the front speed sensor with the bolt.
  Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf)
  
  NOTE:
  Make sure that the sensor tip is clean.
2. Connect the skid control sensor connector.
INSTALL FRONT WHEEL
Torque: 112 N*m (1137 kgf*cm, 82 ft.*lbf)
CHECK VSC SENSOR SIGNAL
Refer to TEST MODE PROCEDURE