Cruise Control Main Switch: Inspection: Inspection
- INSPECT CRUISE CONTROL MAIN SWITCH
- for cruise control system:
- Measure the resistance according to the value(s) in the table below.TEXT IN ILLUSTRATION
*1 Component without harness connected
(Cruise Control Main Switch)*2 Main Switch *3 Lever *4 ON/OFF *5 - SET *6 + RES *7 CANCEL - - Standard Resistance
Tester Connection Switch Condition Specified Condition 1 - 3 Main Switch off*1 1 MΩ or higher Main Switch on Below 2.5 Ω + RES 235 to 245 Ω - SET 617 to 643 Ω CANCEL 1509 to 1571 Ω *1: Lever is in the neutral position
If the result is not as specified, replace the cruise control main switch.
- Measure the resistance according to the value(s) in the table below.
- for dynamic radar cruise control system:
- Measure the resistance according to the value(s) in the table below.TEXT IN ILLUSTRATION
*1 Component without harness connected
(Cruise Control Main Switch)*2 ON/OFF *3 CANCEL *4 - SET *5 + RES *6 MODE Standard Resistance
Tester Connection Switch Condition Specified Condition 1 - 2
1 - 3Main Switch off*1 1 MΩ or higher 1 - 3 Main switch on Below 2.5 Ω 1 - 2 MODE Below 2.5 Ω 1 - 3 + RES 235 to 245 Ω 1 - 3 - SET 617 to 643 Ω 1 - 3 CANCEL 1509 to 1571 Ω *1: Lever is in the neutral position
If the result is not as specified, replace the cruise control main switch.
- Measure the resistance according to the value(s) in the table below.
- for cruise control system: