LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2013 >> Venza Limited, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (2GR-FE) (Service Information) >> Air Fuel Ratio Sensor >> Removal >> Removal
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Air Fuel Ratio Sensor: Removal: Removal

  1. REMOVE COOL AIR INTAKE DUCT SEAL  . Refer to REMOVAL - Step 17
  2. REMOVE V-BANK COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 18
  3. REMOVE AIR FUEL RATIO SENSOR NO. 2 (for Bank 2 Sensor 1) 
    1. Disconnect the air fuel ratio sensor connector, and separate the wire harness clamp.
      Fig 1: Locating Air Fuel Ratio Sensor Connector And Wire Harness Clamp
      GTY249651Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using SST, remove the air fuel ratio sensor from the exhaust manifold LH.
      Fig 2: Removing Air Fuel Ratio Sensor Using SST
      GTY248518Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09224-00010 
  4. REMOVE FRONT DOOR SCUFF PLATE LH  . Refer to REMOVAL - Step 1
  5. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH  . Refer to REMOVAL - Step 2
  6. REMOVE NO. 3 FRONT EXHAUST PIPE SUB-ASSEMBLY  . Refer to REMOVAL - Step 8
  7. REMOVE MANIFOLD STAY  . Refer to REMOVAL - Step 9
  8. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH  . Refer to REMOVAL - Step 10
  9. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) 
    1. Using SST, remove the air fuel ratio sensor from the exhaust manifold RH.
      Fig 3: Removing Air Fuel Ratio Sensor Using SST
      GTY251159Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09224-00010 
scientia non olet · About LEMON Manuals