DTC P0607-00: Control Module Performance: Procedure

1. Clear the DTC from the ECM memory using the Techstream.

   Refer to AFTER REPAIR PROCEDURE

2. Perform the KOEO or KOER self test.

   Refer to ON-DEMAND SELF-TEST/KEY-ON ENGINE RUNNING SELF-TEST

3. Is the same DTC present?

   Result

   Result
   Yes
   No

Result:  2

Yes 

See step  3

Result:  1

No 

See step  2

1. Perform the "AFTER REPAIR PROCEDURE".

   Refer to AFTER REPAIR PROCEDURE

2. Are any DTCs present?

   Result

   Result
   Yes
   No

Result:  1

No 

DTC TROUBLESHOOTING COMPLETED. 

Result:  2

Yes 

GO TO THE APPLICABLE DTC INSPECTION. 

1. Refer to DIAGNOSTIC TROUBLE CODE CHART

1. Refer to REMOVAL
2. Then go to the next step.

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  2