LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2019 >> RAV4 Limited, 4WD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Stop And Start System Cancel Switch Assembly - Service Information >> Stop And Start System Cancel Switch Assembly >> Inspection [11/2018 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection [11/2018 - ]: Procedure

  1. INSPECT ECO RUN CANCEL SWITCH ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.
      GTY871984Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Eco Run Cancel Switch Assembly)

      Standard Resistance

      Tester Connection Switch Condition Specified Condition
      5 (ECU) - 2 (E) Pushed Below 1 Ω
      Not pushed 10 kΩ or higher

      If the result is not as specified, replace the eco run cancel switch assembly.

    2. Apply battery voltage between the terminals of the switch, and check the illumination condition of the eco run cancel switch assembly.

      OK

      Measurement Condition Specified Condition
      Battery positive (+) → 6 (ILL+)
      Battery negative (-) → 1 (ILL-)      		 Illuminates

      If the result is not as specified, replace the eco run cancel switch assembly.

      GTY871988Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Eco Run Cancel Switch Assembly)
scientia non olet · About LEMON Manuals