Inspection [11/2018 - ]: Procedure
- INSPECT ECO RUN CANCEL SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Eco Run Cancel Switch Assembly)Standard Resistance
Tester Connection Switch Condition Specified Condition 5 (ECU) - 2 (E) Pushed Below 1 Ω Not pushed 10 kΩ or higher If the result is not as specified, replace the eco run cancel switch assembly.
- Apply battery voltage between the terminals of the switch, and check the illumination condition of the eco run cancel switch assembly.
OK
Measurement Condition Specified Condition Battery positive (+) → 6 (ILL+)
Battery negative (-) → 1 (ILL-)Illuminates If the result is not as specified, replace the eco run cancel switch assembly.
*a Component without harness connected
(Eco Run Cancel Switch Assembly)
- Measure the resistance according to the value(s) in the table below.