DTC P060B: Internal Control Module A/D Processing Performance [08/2019 - ]: Procedure

CHECK FOR DTC
1. Clear the DTCs.
  Refer to DTC CHECK / CLEAR [08/2019 - ]
2. Turn the ignition switch off.
3. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
4. Connect the cable to the negative (-) battery terminal.
5. Turn the ignition switch to ON.
6. Check for DTCs.
  OK
  
  P060B is not output.
Result:

OK

CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [08/2015 - ]

Result:

NG

REPLACE ECM. Refer to REMOVAL [08/2015 - ]