Inspection [11/2015 -]: Procedure
- INSPECT ENGINE OIL LEVEL SENSOR
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
(C28)
(C28)
Tester Connection Condition Specified Condition C28-1 - Body ground ON Below 1 Ω C28-1 - Body ground OFF 10 kΩ or higher *a Component without harness connected
(Engine Oil Level Sensor)*b Engine Oil Level Sensor Body *c ON *d OFF If the result is not as specified, replace the engine oil level sensor.
- Measure the resistance according to the value(s) in the table below.