LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2022 >> GR86 Base, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Diagnostic Codes (3 Of 6) >> SFI System >> DTC P0604: Internal Control Module Random Access Memory (RAM) Error [11/2021 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0604: Internal Control Module Random Access Memory (RAM) Error [11/2021 - ]: Procedure

  1. CHECK DTC 
    1. Turn the ignition switch to ON.
    2. Using GTS or a general scan tool, read the DTC of [Engine].

      Powertrain > Engine Control System > Trouble Codes 

      Is DTC other than P0604 displayed? (Current code)

      Result Proceed to
      Yes (Check the appropriate DTC using the "Diagnostic Trouble Code (DTC)".) A
      No (Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.)
      HINT: 
      In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
      B

    Result: 

    CHECK APPROPRIATE DTC 

    Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2021 - 06/2022] , or refer to DIAGNOSTIC TROUBLE CODE CHART [06/2022 - 12/2023] , or refer to DIAGNOSTIC TROUBLE CODE CHART [12/2023 - 10/2024] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2024 - ]

    Result: 

    PERFORM SIMULATION TEST