Surround Vision Camera System Calibration (Launch Mobile): Notes
Mobile Repair Possible: No
Special Tools Required:
Launch Mobile ADAS Calibration Equipment - No Part Number
VF8/VF9 Surround View Mats (LAC04-32-1 and LAC04-32-2) - No Part Number
Required Setup Area:
Ensure the vehicle is placed in a location with sufficient clear space around the vehicle:
- Surround View Camera Calibration - 5.3 meters by 8.3 meters area
Workstation and Vehicle Setup Considerations:
- FLAT and UNIFORM FLOOR SURFACE with sufficient space for the vehicle and equipment at same level
- UNIFORM and BRIGHT ILLUMINATION by a non-frequency flash light source such as:
- LED Lights
- Industrial Lighting complying with international standards
- Dual Light Source in opposite phase
- Light source should ensure NO REFLECTED SPOTS or SHADOWS on calibration targets
- Avoid excessive natural light through windows or door openings
- Avoid changes in brightness such as vehicles driving past with lights on
- Vehicle should be in PARK and "Driver Present" mode (Ignition ON but eMotor OFF)
- Steering Wheel CENTERED pointing straight ahead
- Doors and Hood in CLOSED position
- Mirrors in UNFOLDED position
- All Vehicle Exterior Lights OFF
- Tires INFLATED to specification
- Vehicle wheel alignment within specification
Key Measurements:
Surround View Camera Mats must be:
- LAC04-32-1: Positioned with the inner edge 1050 mm laterally from the vehicle centre line.
- LAC04-32-2: Positioned so that the inner edges of the longitudinal mats align with the outer edges and corners of the front and rear mats.
- The label tabs (1) of the LAC04-32-2 always have to be positioned the inner edge closest to the vehicle. Refer to the picture above.