Windshield Camera Calibration (Launch Mobile): Notes
Mobile Repair Possible: No
Required Setup Area:
Ensure the vehicle is placed in a location with sufficient clear space around the vehicle:
- Front Windshield Camera Calibration - 1 meter either side of the vehicle and 3 meters in front
Workstation and Vehicle Setup Considerations:
- FLAT and UNIFORM FLOOR SURFACE with sufficient space for the vehicle and equipment at same level
- UNIFORM and BRIGHT ILLUMINATION by a non-frequency flash light source such as:
- LED Lights
- Industrial Lighting complying with international standards
- Dual Light Source in opposite phase
- Light source should ensure NO REFLECTED SPOTS or SHADOWS on calibration targets
- Avoid excessive natural light through windows or door openings
- Avoid changes in brightness such as vehicles driving past with lights on
- Vehicle should be in PARK and "Driver Present" mode (Ignition ON but eMotor OFF)
- Steering Wheel CENTERED pointing straight ahead
- Doors and Hood in CLOSED position
- Mirrors in UNFOLDED position
- All Vehicle Exterior Lights OFF
- Tires INFLATED to specification
- Vehicle wheel alignment within specification
Key Measurements:
Front windshield camera target pattern boards (LAM01-07-L and LAM01-07-R) must be aligned with vehicle centre line and:
- Positioned 2900 mm forward of the centre line of the front axle.
- Mounted at a height of 1530.4 mm (+/- 10 mm) from the ground to the centre line of the target