Service Precautions
Observe these precautions when working with air bag systems:
- DO NOT use computer memory saver tool. Using computer memory tool will keep air bag system active and may cause accidental deployment of air bag unit.
- Disable air bag system before servicing any air bag system or steering column component. See DISABLING & ACTIVATING AIR BAG SYSTEM.
- Because of critical operating requirements of system, DO NOT attempt to service any air bag system component.
- Air bag parts should not be left unattended. They should be installed in vehicle immediately after obtaining them.
- Air bag components which have been dropped more than 18 inches should not be used.
- Chemical cleaners, oil and grease should not contact vinyl covering on air bag unit.
- DO NOT place stickers or covers on steering wheel.
- Always disable air bag system before performing electric welding on vehicle.
- Air bag system can only be tested using Diagnostic Tester (VAG 1551 ). Never use test light on air bag system.
CAUTION:
Applying excessive pressure or causing impact to mainshaft during service may cause the column to disengage.