Engine Control Module, Additional DTCS Programmed For Same Condition (GROUP 01, NO. 07-34)

Publication date: 2007-04-05
Reference number: GROUP 01, NO. 07-34
Supersedes refnos: 2010552, GROUP 01, NO. 04-08

ENGINE CONTROL MODULE, ADDITIONAL DTCS PROGRAMMED FOR SAME CONDITION

TECHNICAL SERVICE BULLETIN

Reference Number(s): GROUP 01, NO. 07-34 (2010552), Date of Issue: April 5, 2007

VOLKSWAGEN:	All
GROUP:	01 - On-Board Diagnostic

Superceded Bulletin(s): GROUP 01, NO. 04-08, Date of Issue: April 20, 2004

SERVICE INFORMATION

VIN RANGE

Model(s)	Year	Eng. Code	Trans. Code	VIN Range From	VIN Range To
All	2004	BGD, BEV	All	All	All

CONDITION

NOTE: 01 07 34 Apr. 5, 2007, 2010552, Supersedes Technical Bulletin Group 01 number 04-08 dated April 20, 2004 due to inclusion in ElsaWeb.

Engine Control Module, Additional DTCs Programmed for Same Condition

Additional DTCs may be stored for the same condition.

TECHNICAL BACKGROUND

Not applicable.

PRODUCTION SOLUTION

Not applicable.

SERVICE

The following information applies to DTCs found using a Generic Scan Tool (GST).

For each condition, one of the DTCs in that row listed under "Version 1" or "Version 2" may be stored.

Diagnose and repair cause of DTC according to corrective action listed (see Generic Scan Tool Manual DTC for complete repair procedures).

Tip: Where applicable, always check wiring and connections as outlined in repair procedures.

DIAGNOSTIC TROUBLE CODES

DTC Version 1	DTC Text	DTC Version 2	DTC Text	Corrective action
P0418	Secondary Air Injection System Control "A" Circuit	P2258	Secondary Air Injection System Control "A" Circuit high	Check activation of Secondary Air Injection (AIR) Pump Relay -J299-. Use corrective action in GST Repair Manual for P2258. See Electrical Wiring Diagrams, Troubleshooting, and Component Locations.
P0418	Secondary Air Injection System Control "A" Circuit	P2257	Secondary Air Injection System Control "A" Circuit low	Check activation of Secondary Air Injection (AIR) Pump Relay -J299-. Use corrective action in GST Repair Manual for P2257. See Electrical Wiring Diagrams and Component Locations.
P3211	Exhaust (Bank1 Sensor1) Heater return connection	P2231	O2 Sensor Signal Circuit Shorted to Heater Circuit (Bank1 Sensor1)	Check oxygen sensor heater for oxygen sensors before Three-Way Catalytic Converter (TWC). Use corrective action in GST Repair Manual for P3211.
P0130	O2 Sensor Circuit (Bank1 Sensor1)	P2251	O2 Sensor Negative Current Control Circuit open (Bank1 Sensor1)	Check Oxygen Sensor (O2S) and oxygen sensor control before Three-Way Catalytic Converter (TWC). Use corrective action in GST Repair Manual for P2251.
P0130	O2 Sensor Circuit (Bank1 Sensor1)	P2243	O2 Sensor Reference Voltage Circuit open (Bank1 Sensor1)	Check Oxygen Sensor (O2S) and oxygen sensor control before Three-Way Catalytic Converter (TWC). Use corrective action in GST Repair Manual for P2243.
P0130	O2 Sensor Circuit (Bank1 Sensor1)	P2626	O2 Sensor Pumping Current Trim Circuit open (Bank1 Sensor1)	Check Oxygen Sensor (O2S) and oxygen sensor control before Three-Way Catalytic Converter (TWC). Use corrective action in GST Repair Manual for P2626.
P0139	O2 Sensor Circuit Slow Response (Bank1 Sensor2)	P2270	O2 Sensor Signal Stuck Lean (Bank1 Sensor2)	Check Oxygen Sensors (O2S) and oxygen sensor control behind Three-Way Catalytic Converter (TWC). Use corrective action in GST Repair Manual for P2270.
P0139	O2 Sensor Circuit Slow Response (Bank1 Sensor2)	P2271	O2 Sensor Signal Stuck Rich (Bank1 Sensor2)	Check Oxygen Sensors (O2S) and oxygen sensor control behind Three-Way Catalytic Converter (TWC). Use corrective action in GST Repair Manual for P2271.
P0030	H02S Heater Control Circuit (Bank1 Sensor1)	P0606	ECM / PCM Processor	Replace Motronic Engine Control Module (ECM) -J220-. Use corrective action in GST Repair Manual for P0606.
P0032	H02S Heater Control Circuit High (Bank1 Sensor1)	P0135	02 Sensor Heater Circuit (Bank1 Sensor1)	Check oxygen sensor heater for Oxygen Sensor (02S) before Three-Way Catalytic Converter (TWC). Use corrective action in GST Repair Manual for P0135.
P0031	H02S Heater Control Circuit Low (Bank1 Sensor1)	P0135	02 Sensor Heater Circuit (Bank1 Sensor1)	Check oxygen sensor heater for Oxygen Sensor before Three-Way Catalytic Converter (TWC). Use corrective action in GST Repair Manual for P0135.
P0642	Sensor Reference Voltage "A" Circuit Low	P0324	Knock Control System Error	Replace Motronic Engine Control Module (ECM) -J220-. Use corrective action in GST Repair Manual for P0606.
P0606	ECM / PCM Processor	P0106	Manifold Absolute Pressure / Barometric Pressure Circuit Range / Performance	Replace Motronic Engine Control Module (ECM) -J220-. Use corrective action in GST Repair Manual for P0606.
P0602	Control Module Programming Error	P1681	Control Module Programming not finished	Replace Motronic Engine Control Module (ECM) -J220-. Use corrective action in GST Repair Manual for P0602.

WARRANTY

Information only.

REQUIRED PARTS AND TOOLS

No special tools required.

No special parts required.