Ignition Components Overview
NOTE:
The engine speed sensor -G28- is on the cylinder block.
- Ignition Coil with Power Output Stage -N70, N127, N291, N292, N323, N324-
- Remove and install using the ignition coil puller T10095 A.
- Connector
- Black
- Use the assembly tool T10118 to disconnect.
- Bracket
- For the harness connector for the knock sensor 1.
- Bolt
- 20 Nm
- Connector
- Black, 3 pin
- Sensor contacts and connector contacts are gold plated.
- Knock Sensor (KS) 1 -G61-
- Installed location - exhaust side of the cylinder block.
- Bolt
- 20 Nm
- Tightening specification affects the function of the knock sensor.
- Exhaust Camshaft Adjuster
- Identification: 32A
- With the sensor wheel for the Camshaft Position (CMP) sensor 2.
- Removing and installing, refer to CAMSHAFT ADJUSTER WITH TIMING CHAIN, INSTALLING .
- Cover
- Connector
- Black, 3 pin
- Sensor contacts and connector contacts are gold plated.
- Mark the connector before disconnecting.
- Bolt
- 10 Nm
- Camshaft Position (CMP) Sensor 2 -G163-
- For the exhaust camshaft.
- Sensor contacts and connector contacts are gold plated.
- Seal
- Always replace
- Camshaft Position (CMP) Sensor -G40-
- For the intake camshaft.
- Sensor contacts and connector contacts are gold plated.
- Knock Sensor (KS) 2 -G66-
- Installed location - intake side of the cylinder block.
- Sensor contacts and connector contacts are gold plated.
- Connector
- Black, 2 pin
- Sensor contacts and connector contacts are gold plated.
- Intake Camshaft Adjuster
- Identification: 24E
- With the sensor wheel for the CMP sensor.
- Removing and installing, refer to CAMSHAFT ADJUSTER WITH TIMING CHAIN, INSTALLING .
- Spark Plug
- 18 Nm
- If the spark plug is replaced, grease the ignition coil with power output stage. Refer to IGNITION COILS WITH POWER OUTPUT STAGES .
- Remove and install using the spark plug removal tool 3122B.
- Type and electrode gap, refer to TECHNICAL DATA .
- Control Housing
- For the camshaft adjustment.
- Removing and installing, refer to CAMSHAFTS .