Diagnostic Mode 01 - Read Current System Data
Diagnostic Mode 01 makes it possible to access current emissions-related measured values and diagnostic data. The original measured values (no replacement values), input and output data and system status information are displayed using Diagnostic Mode 1.
Depending on scan tool and protocol used, the information displayed in diagnostic mode 01 may be referred to by different names such as Test-ID (TID), Hex-ID, Component-ID (CID), On-Board Diagnostic Monitor Identifier (OBDMID), or contain no name at all and be referenced by only a number.
Test requirement
- Coolant temperature at least 80° C.
Procedure
-- Connect the scan tool.
-- Start the engine and run at idle.
-- Select "Diagnostic Mode 01 - Obtain Data.".
-- From the following table, select the desired the "PID" that is to be monitored, e.g. "PID 05 Coolant temperature".
The current values of the component or system that is being monitored will be displayed on the scan tool screen.
| PID | Component or System |
|---|---|
| 01: | Monitoring status since erasing DTC memory |
| 03: | Condition of fuel system |
| 04: | Calculated load condition value |
| 05: | Coolant temperature |
| 06: | Short term gasoline-air ratio bank 1 |
| 07: | Gasoline-air ratio bank 1 |
| 12: | Engine rotations per minute (RPM) |
| 13: | Vehicle speed |
| 14: | Ignition timing adjustment at 1. cyl. in direction |
| 15: | Intake air temperature (IAT) |
| 16: | Air flow quantity at Mass Air Flow (MAF) sensor |
| 17: | Throttle valve position (absolute) |
| 19: | Existing oxygen B1 to B2-S2 to (exist./nonexist.) |
| 21: | Bank 1 - sensor 2 |
| 28: | OBD request is designed for diagnostic of this vehicle |
| 31: | Time after engine on |
| 33: | Driven distance after MIL on |
| 35: | Fuel Rail Pressure |
| 46: | Commanded Evaporative Purge |
| 48: | Number of warm ups since diagnostic trouble codes |
| 49: | Distance since diagnostic trouble codes cleared |
| 51: | Barometric Pressure |
| 52: | Bank 1 - sensor 1 |
| 56: | Bank 2- sensor 1 |
| 60: | Catalyst Temperature Bank 1, Sensor 1 |
| 65: | Monitor status this driving cycle |
| 66: | Control module voltage |
| 67: | Absolute Load Value |
| 68: | Commanded Equivalence Ratio |
| 69: | Relative Throttle Position |
| 70: | Ambient air temperature |
| 71: | Absolute Throttle Position B |
| 73: | Accelerator Pedal Position D |
| 74: | Accelerator Pedal Position E |
| 76: | Commanded Throttle Actuator Control |
-- Switch the ignition off.
End of Procedure