LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Volkswagen >> 2012 >> Passat TDI SE, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> 2.0L - Generic Scan Tool - Engine Code: CKRA >> St Generic Scan Tool >> Diagnosis And Testing >> Diagnostic Procedures >> Can Bus Terminal Resistance, Checking >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

NOTE:

The engine control module must remain connected for the following step.

-- Using a multimeter, measure the resistance between the CAN bus low and CAN bus high in the CAN bus disconnection plug electrical connector. Refer to Wiring Diagrams for location.

-- Disconnect the transmission control module electrical connector.

-- Using a multimeter, measure the resistance between the CAN bus low and CAN bus high from the transmission control module.

Data Bus On Board Diagnostic Interface -J533- electrical harness T20 D connector terminals Direct Shift Gearbox (DSG) Mechatronic -J743- electrical harness connector T20 E terminals
6 Data - 15
16 Data + 10

Specified value: 60 to 72 Ω (at approx. 20° C)

If the specified value was not obtained:

scientia non olet · About LEMON Manuals