Final Procedures

-- Make sure Transfer fuel pump relay has been reinstalled properly and all connectors have been plugged back in.

-- Reinstall the engine cover with air filter, if necessary. Refer to the appropriate service information.

-- After the repair work, the following work steps must be performed in the following sequence:

1. Check the DTC memory. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY .
2. If necessary, erase the DTC memory. Refer to DIAGNOSTIC MODE 04 - ERASE DTC MEMORY .
3. If the DTC memory was erased, generate readiness code. Refer to READINESS CODE .