Engine Mount Adjustment, Checking

WARNING: This page is about a different variant/trim than selected.

There must be at least 10 to 13 mm -a- between the engine mount bracket -2- and right longitudinal member.

Fig 1: Identifying Casting Edge On Engine Support Location
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
The casting edge on the engine mount bracket -2- must be parallel to the engine mount support arm -1-, dimension -x- must be the same at the front and the rear.

Only if there is a noise (the engine or transmission hitting the longitudinal member when driving around curves) and dimension -a- is NOT within 10 to 13 mm:

-- Adjust the engine mount. Refer to ENGINE/TRANSMISSION MOUNT, ADJUSTING .