Test Step 9 - Power Liftgate Module
- Reconnect the power liftgate module C1 harness connector.
- Reconnect the power liftgate module C2 harness connector.
- Reconnect the power liftgate drive unit harness connector.
- Turn the ignition ON.
- While back probing, measure the voltage between ground and the position sensor supply circuit in the power liftgate drive unit harness connector.
NOTE:
The graphic shows the terminal end of the connector for reference only. Back probe the wire end of the connector
Is the voltage approximately 4.8 volts?
Yes
- Go to Test Step 10 Test Step 10 - Power Liftgate Drive Unit
No
- Replace the power liftgate module. Refer to POWER LIFTGATE CONTROL MODULE .
- Perform the Body Verification Test. Refer to BODY VERIFICATION TEST .