Test Step 2 - Power Liftgate Module

Fig 1: Testing Power Liftgate Module

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

• Turn the ignition OFF.
• Disconnect the power liftgate module C1 harness connector.
• Measure the resistance between the liftgate open driver circuit and the liftgate close driver circuit.

Is the resistance approximately 4.3 ohms?

No

• Go to Test Step 3 Test Step 3 - Liftgate Open Driver Circuit Open 

Yes

• Replace the power liftgate module. Refer to POWER LIFTGATE CONTROL MODULE .
• Perform the Body Verification Test. Refer to BODY VERIFICATION TEST .