Test Step 9 - Power Liftgate Module

• Reconnect the power liftgate module C1 harness connector.
• Reconnect the power liftgate module C2 harness connector.
• Reconnect the power liftgate drive unit harness connector.
• Turn the ignition ON.
• While back probing, measure the voltage between ground and the position sensor supply circuit in the power liftgate drive unit harness connector.

Is the voltage approximately 4.8 volts?

Yes

• Go to Test Step 10 Test Step 10 - Power Liftgate Drive Unit 

No

• Replace the power liftgate module. Refer to POWER LIFTGATE CONTROL MODULE .
• Perform the Body Verification Test. Refer to BODY VERIFICATION TEST .