Test Step 6 - Liftgate Open Driver Wire Short to Liftgate Close Driver Wire
- Disconnect the power liftgate drive unit connector.
- Measure the resistance between the liftgate open driver circuit and the liftgate close driver circuit.
- Wiggle the harness and check for an intermittent short circuit condition.
Is the resistance less than 10k ohms?
Yes
- Repair the liftgate open driver circuit for a short to the liftgate close driver circuit.
- Perform the Body Verification Test. Refer to BODY VERIFICATION TEST .
No
- Replace the power liftgate drive unit. Refer to POWER LIFTGATE DRIVE UNIT .
- Perform the Body Verification Test. Refer to BODY VERIFICATION TEST .