Rearview Camera System, Calibrating: Notes

Special tools and workshop equipment required 

• Calibration Tool VAS6350

After performing service work on the vehicle, it may be necessary to calibrate the rear view camera system anew. In detail, this is the case after: 

• removing and installing rear view camera
• replacing the rearview camera system control module
• after repair work performed on rear lid following an accident
• the standing height of one axle changes by more than 5 mm
• the standing height of the entire vehicle changes by more than 10 mm.

There is some work, which must be performed, before performing the actual calibration. Use the Vehicle Diagnostic Tester as described in the following.