| 1 |
- PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK
-- Was complaint verified? |
-- YES:
-- NO:
- Gather more Information from customer about the complaint
|
| 2 |
- DISCONNECT: Intake Manifold Temperature Sensor -G72- electrical connector
- IGNITION: OFF
- CHECK: Intake Manifold Temperature Sensor -G72- wiring connector terminals 1 to 2 for voltage.
- SPECIFIED VALUE: About 5.0 V.
-- Was value obtained? |
-- YES:
-- NO:
|
| 3 |
- REMOVE: Engine Control Module - J623-. Refer to appropriate repair information.
- CHECK: Manifold Absolute Pressure Sensor -G71- harness connector terminal 2 to the Engine Control Module - J623- harness connector T60 / 40 for resistance.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω)
-- Was value obtained? |
-- YES:
- REPLACE: Intake Manifold Temperature Sensor -G72-. Refer to appropriate repair information.
- GO TO: Step 5
-- NO:
- CHECK: wiring for open, high resistance, short or electrical connector for damage, corrosion, loose or broken terminals
- REPAIR: faulty wiring or connector
- GO TO: Step 5
|
| 4 |
- REMOVE: Engine Control Module - J623-. Refer to appropriate service information.
- CHECK: Intake Manifold Temperature Sensor -G72- electrical connector terminals 1 to the Engine Control Module - J623- electrical connector terminals T60 / 24.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω)
-- Was value obtained? |
-- YES:
- REPLACE Engine Control Module -J623- Refer to appropriate repair information
- GO TO: Step 5
-- NO:
- CHECK: wiring for open, high resistance, short or electrical connector for damage, corrosion, loose or broken terminals
- REPAIR: faulty wiring or connector
- GO TO: Step 5
|
| 5 |
- Final Procedure
- Perform a road test to verify repair.
- Do any DTC's return:
|
-- YES:
-- NO:
- Repair is complete, Generate readiness code. Refer to READINESS CODE .
- Return vehicle to Customer
|