Overview - Abs Mark 60 EC (Abs/EDL/ASR/Esp)

Fig 1: Exploded View Of ABS Mark 60 EC (ABS/EDL/ASR/ESP)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

ABS Hydraulic Unit -N55-
- Removing and installing. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .
- Disconnecting the ABS Control Module -J104- from the ABS Hydraulic Unit -N55-. Refer to ABS Control Module -J104-, SEPARATING FROM ABS Hydraulic Unit -N55- (ABS MARK 60 EC ABS/EDL/ASR/ESP) .
ABS Control Module -J104-
- Removing and installing. Refer to ABS Control Module -J104- /ABS Hydraulic Unit -N55-, REMOVING AND INSTALLING .
- Disconnecting the ABS Control Module -J104- from the ABS Hydraulic Unit -N55-. Refer to ABS Control Module -J104-, SEPARATING FROM ABS Hydraulic Unit -N55- (ABS MARK 60 EC ABS/EDL/ASR/ESP) .
Bolt
- 2 Nm ± 0.8 Nm
- Replace after removing.
- Quantity: 4
Brake Line
- 14 Nm
- To the left front brake caliper
- Identification: 5.25 mm diameter and tube fitting with a M10 x 1 thread
Brake Line
- 14 Nm
- ABS Hydraulic Unit -N55- for the brake master cylinder/primary piston circuit
- Identification: 6.5 mm diameter and tube fitting with a M12 x 1 thread
Brake Line
- 14 Nm
- To the right front brake caliper
- Identification: 5.25 mm diameter and tube fitting with a M12 x 1 thread
Brake Line
- 14 Nm
- ABS Hydraulic Unit -N55- to the brake master cylinder/secondary piston circuit.
- Identification: 6.5 mm diameter and tube fitting with a M12 x 1 thread
Brake Line
- 14 Nm
- Brake master cylinder/primary piston circuit to the ABS Hydraulic Unit -N55-
- Identification: 6.5 mm diameter and tube fitting with a M12 x 1 thread
Brake Line
- 14 Nm
- Brake master cylinder/secondary piston circuit to the ABS Hydraulic Unit -N55-
- Identification: 6.5 mm diameter and tube fitting with a M12 x 1 thread
Brake Booster with Master Brake Cylinder
- Refer to BRAKE BOOSTER/BRAKE MASTER CYLINDER
- Brake booster, removing and installing. Refer to BRAKE BOOSTER, REMOVING AND INSTALLING .
- Brake master cylinder, removing and installing. Refer to BRAKE MASTER CYLINDER, REMOVING AND INSTALLING .
Brake Line
- 14 Nm
- To left rear brake caliper/brake cylinder
- Identification: 5.25 mm diameter and tube fitting with a M12 x 1 thread
Brake Line
- 14 Nm
- To the right rear brake caliper/brake cylinder
- Identification: 5.25 mm diameter and tube fitting with a M10 x 1 thread
Hex Fitting Bolt
- 8 Nm
Rubber Bushing
Bracket
- After installing, make sure it fits properly
Bolt
- 8 Nm
- Quantity: 3
Nut
- 8 Nm
- Quantity: 2
Bracket
Rubber Bushing
- Do not press the rubber bushings out of the bracket when installing the bracket.