Test Procedure

-- Observe safety precautions. Refer to SAFETY PRECAUTIONS

-- Observe Clean Working Conditions. Refer to CLEAN WORKING CONDITIONS

-- Perform a preliminary check to verify the customers complaint. Refer to PRELIMINARY CHECK .

Leak checking

-- Using a smoke tester, check the Evaporative Emission (EVAP) system for leaks.

NOTE:

Always follow the manufacturers directions for the proper installation and operation of the smoke tester being used.

If a leak is detected:

-- Check the fuel filler cap seal for damage and for proper installation. Replace if necessary.

-- Check the seals under the locking flanges and the union nuts are properly tightened on the fuel tank.

-- Check all hose connections of the fuel supply system and replace or repair any leaking lines.

-- Check all hose connections of the EVAP system and replace or repair any leaking lines.

-- Repair or replace any damaged component.

If no leaks are found in the EVAP and Fuel Supply System:

-- Erase the DTC memory if a DTC was set. Refer to DIAGNOSTIC MODE 04 - ERASE DTC MEMORY .

-- Perform a road test to verify repair.

If the DTC was set and does not return:

Generate readiness code. Refer to READINESS CODE .

If the DTC does return and no leaks are found in the EVAP and Fuel Supply System:

-- Check for any DTC codes pertaining to the EVAP and Fuel Supply Systems. If a DTC is stored, perform the diagnostic test procedure for the suspected component. Refer to DIAGNOSTIC MODE 03 - READ DTC MEMORY .