Button In Handle, Moving Into Installation Position

If the button was pushed in by mistake, the installed position can be set again.

There are two ways to move the button into the installation position, >>with<< or >>without<< assembly fastener. The following describes both ways.

Moving the handle >>with<< an assembly fastener into the installation position:

Make sure the assembly fastener has an eye -arrow- at the front. Other assembly fasteners cannot be used.

Fig 1: Assembly Aid Eye

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the button and push the assembly fastener (with the eye) -arrow- all the way in until it latches into place. Then release the button. The button locks into the installation position when the assembly fastener is pulled out.

Fig 2: Identifying Pressing Button And Pushing Assembly Aid (With Eye)

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Moving the handle >>without<< an assembly fastener into the installation position:

-- Remove the trim -A- from the handle.

Fig 3: Identifying Handle Trim

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the small lever -1- into the groove -2- with a screwdriver. This pushes the button -3- into the installation position.

Fig 4: Identifying Small Lever Pushed Into Groove With Screwdriver, Pushing Button Into Installed Position

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-I- the button is in the pressed position

-II- the button is in the installation position