Specifications Index
SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | REFRIGERANT R134A PHYSICAL DATA | ||
| Torque | Fastener Tightening Specifications | ||
| Axle Nut/Hub Nut | |||
| Front | 70 Nm +90° | ||
| Rear | 70 Nm +90° | ||
| Battery | BATTERY | ||
| Brakes | |||
| Bleeding Sequence | Brake System, Bleeding | ||
| Disc Brakes | FRONT BRAKES, FN 3 | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS
Mechanical Components Fastener Tightening Specifications Hydraulic Components |
||
| Charging | |||
| Generator | N/A | ||
| Torque | |||
| Drive Belts | |||
| Adjustment | |||
| 2.0L | Ribbed Belt | ||
| Belt Routing | |||
| 2.0L | See the figure under Installing | ||
| Engine Cooling | |||
| General Service Specifications | Refer to the approrpiate FLUID CAPACITY TABLES information. | ||
| Radiator Cap Pressure | |||
| 2.0L | 1.4 to 1.6 bar (20.30 to 23.20 psi) | ||
| Thermostat R & I | |||
| 2.0L | COOLANT THERMOSTAT | ||
| Water Pump R & I | |||
| 2.0L | COOLANT PUMP | ||
| Engine Mechanical | |||
| 2.0L | |||
| Compression | Compression Pressure, Checking | ||
| Oil Pressure | Start the engine and increase the engine speed: The LED must illuminate at 1.2 to 1.6 bar (17.40 to 23.20 psi). At 2000 RPM and an oil temperature of 80°C (176°F), the oil pressure must be between 2.0 to 4.5 bar (29.00 to 65.26 psi). |
||
| Overhaul | 10 ENGINE ASSEMBLY | ||
| Torque | Fastener Tightening Specifications | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||
| Engine Oil Drain Plug | 30Nm | ||
| Flywheel/Flex Plate Torque | 60 Nm + an additional 90° (1/4) turn | ||
| Fuel System | |||
| Pressure Specification | |||
| 2.0L | The fuel injection system is separated into a high pressure side, where the pressure is a maximum of approximately 120 bar (1, 740 psi) and a low pressure side, where the pressure is approximately 6 bar (87.02 psi). | ||
| Fuel Pressure Test Procedure | |||
| 2.0L | Fuel Pressure Sensor -G247-, Checking | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Coil-On-Plug | ||
| Ignition Wires (Routing) | Coil-On-Plug | ||
| Spark Plug | |||
| 2.0L | TECHNICAL DATA AND SPARK PLUGS | ||
| Starting | |||
| Starter | STARTER, CHECKING | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFIED VALUES | ||
| Torque | N/A | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | FWD: 140 Nm AWD: 120 Nm |
||