, Connecting to Rear End Module and Sending Mileage to Rear End Module

-- Move the vehicle out of the service facility so that the vehicle has GPS and phone reception.

-- Switch on the ignition and leave it switched on for approximately 10 minutes. Do not connect the Vehicle Diagnostic Tester.

-- After the waiting period is over, check the function of the Control Module for Emergency Call Module and Communication Unit -J949- as follows:

-- Select the Read measured values  function. Refer to Vehicle Diagnostic Tester in the OBD  mode.

-- Select the measured values of the group Online services activation status  .

• The measured value shown for the "Vehicle Health display" must be "activated".

If the measured value shown for the "Vehicle Health display" stays at "not activated", then:

-- Exit OBD  mode and disconnect the Vehicle Diagnostic Tester from the vehicle.

-- Turn off the ignition.

-- Disconnect the connector from the Control Module for Emergency Call Module and Communication Unit -J949- to reset terminal 30.

-- After waiting a short amount of time, reconnect the connector to the Control Module for Emergency Call Module and Communication Unit -J949-.

-- Restart the procedure for connecting the Control Module for Emergency Call Module and Communication Unit -J949- to the rear end module and sending the mileage to the rear end module. Refer to , Connecting to Rear End Module and Sending Mileage to Rear End Module .

If the measured value shown for the "Vehicle Health display" is at "activated", then:

-- Note the mileage in the instrument cluster.

-- Exit OBD  mode and disconnect the Vehicle Diagnostic Tester from the vehicle.

-- Switch off the ignition and leave it switched off for at least five minutes.

The Control Module for Emergency Call Module and Communication Unit -J949- establishes a connection to the rear end module and sends the current mileage to the rear end module.

Enrollment Process in Customer Web Portal, Checking

-- Log in to the Car-Net customer portal, creating a test account if necessary.

-- Add the vehicle, along with:

• Entering the VIN
• Entering the mileage
• Entering a vehicle name

-- Load the vehicle into the "Dashboard". The following values are shown:

• Mileage
• Charge level
• Various functions, such as starting, charging, climate control and parking position.

-- Delete the vehicle in your own account.

-- When the customer picks up their vehicle, then add the vehicle with the customer and the mileage checked earlier to the customer account.

Enrollment in Customer Web Portal, Checking

-- Check for a successful enrollment as follows:

-- Turn on the ignition.

-- Select the Read measured values  function. Refer to Vehicle Diagnostic Tester in the OBD  mode.

-- Select the measured values of the group Online services activation status  .

• The measured values shown for the subscribed Car-Net services change to "activated".