Control Module, Attaching To Hydraulic Unit: Notes
Special Tools And Workshop Equipment Required
- Torque Screwdriver:VAG1624
- ESD Work Surface:VAS6613
- TORX ® insert T25
Excessive shaking (for example, dropping, impact) can damage the ABS Control Module -J104-. Do not use the ABS Control Module -J104- again if this happens.
- Surface must be cleaned before assembling.
-- Place the ABS Control Module -J104- on the ABS Hydraulic Unit -N55- without tilting it.
-- Tighten the ABS Hydraulic Unit -N55- and the ABS Control Module -J104- with the supplied new TORX® bolts in two steps switching back and forth to the tightening specification.
The ABS Hydraulic Unit -N55- threads for attaching the ABS Control Module -J104- may not be re-cut.
If the thread is damaged, the ABS Hydraulic Unit -N55- must be replaced.
If the bolts are difficult to install by hand or cannot be tightened to the tightening specification, then the thread is damaged.