Control Module, Separating From Hydraulic Unit: Notes
Special Tools And Workshop Equipment Required
- ESD Work Surface:VAS6613
- TORX ® Insert T25
- If the ABS Control Module -J104- is faulty, then the control module is to be separated from the ABS Hydraulic Unit -N55- and only the control module replaced.
- If the ABS Hydraulic Unit -N55- is faulty, then replace the ABS Hydraulic Unit -N55- together with the ABS Control Module -J104-.
- To separate the ABS Control Module -J104- and the ABS Hydraulic Unit -N55- the unit must be removed.
WARNING:
- The return flow pump may also not be separated from the ABS Hydraulic Unit -N55-.
- The circuit board is exposed when the ABS Control Module -J104- is removed.
- Protect the ABS Control Module -J104- from moisture and dirt particles from getting inside.
- Avoid build-up of static electricity!