Overview - Ignition System
WARNING: This page is about a different variant/trim than selected.
NOTE:
The Engine Speed Sensor -G28- is located on the cylinder block. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Ignition Coils with Power Output Stage -N70, N127, N291, N292, N323, N324-
- Removing and installing. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .
- Connector
- Black
- Use the Elbow Assembly Tool :T10118 to remove
- Bracket
- For the Knock Sensor 1 -G61- connector
- Bolt
- 20 Nm
- Connector
- Black, 3-pin
- Gold plated sensor contacts and connector contacts
- Knock Sensor 1 -G61-
- Installed location: cylinder block exhaust side
- Bolt
- 20 Nm
- The tightening specifications affect function of the knock sensor
- Exhaust Camshaft Adjuster
- Identification: 32A
- With sensor wheel for the Camshaft Position Sensor 2 -G163-
- Removing and installing. Refer to CAMSHAFT ADJUSTER, REMOVING AND INSTALLING .
- Cover
- Connector
- Black, 3-pin
- Gold plated sensor contacts and connector contacts
- Mark the connector before disconnecting
- Bolt
- 10 Nm
- Camshaft Position Sensor 2 -G163-
- For the exhaust camshaft
- Gold plated sensor contacts and connector contacts
- Seal
- Always replace
- Camshaft Position Sensor -G40-
- For the intake camshaft
- Gold plated sensor contacts and connector contacts
- Knock Sensor 2 -G66-
- Installed location: cylinder block intake side
- Gold plated sensor contacts and connector contacts
- Connector
- Black, 2-pin
- Gold plated sensor contacts and connector contacts
- Intake Camshaft Adjuster
- Identification: 24E
- With sensor wheel for the Camshaft Position Sensor -G40-
- Removing and installing. Refer to CAMSHAFT ADJUSTER, REMOVING AND INSTALLING .
- Spark Plug
- 18 Nm
- Remove and install with the Spark Plug Removal Tool :3122B
- Type and electrode gap. Refer to TEST DATA AND SPARK PLUGS .
- Control Housing
- For the camshaft adjustment