| 1 |
- PERFORM: Preliminary Check to verify the customers complaint. Refer to: PERFORM: Preliminary Check to verify the customers complaint. Refer to PRELIMINARY CHECK
.
-- Was Complaint verified? |
-- YES: -- NO:
- GATHER more information from customer about the complaint.
|
| 2 |
- IGNITION: OFF.
- DISCONNECT: Intake Manifold Runner Position Sensor -G336- harness connector.
- IGNITION: ON.
- CHECK: Intake Manifold Runner Position Sensor -G336- harness connector terminals 1 to 3 for voltage.
- IGNITION: OFF.
- SPECIFIED VALUE: About 5.0 V.
-- Was Value obtained? |
-- YES: -- NO:
|
| 3 |
- REMOVE: Engine/Motor Control Module - J623-.
- CHECK: Intake Manifold Runner Position Sensor -G336- harness connector terminal 2 to the Engine/Motor Control Module - J623- harness connector T105 / 13 for resistance.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω).
-- Was Value obtained? |
-- YES:
- REPLACE: Intake Manifold Runner Position Sensor -G336-.
- GO TO: Step 5.
-- NO:
- PERFORM: Visual Inspection of wiring and component.
- CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals.
- REPAIR: Faulty wiring or connector.
- GO TO: Step 5.
|
| 4 |
- REMOVE: Engine/Motor Control Module - J623-.
- CHECK: Intake Manifold Runner Position Sensor -G336- harness connector terminal 1 to the Engine/Motor Control Module - J623- harness connector T105 / 12 for resistance.
- CHECK: Intake Manifold Runner Position Sensor -G336- harness connector terminal 3 to the Engine/Motor Control Module - J623- harness connector T105 / 11 for resistance.
- SPECIFIED VALUE: 0.5 Ω (± 0.3 Ω).
-- Were Values obtained? |
-- YES: -- NO:
- PERFORM: Visual Inspection of wiring and component.
- CHECK: Wiring for open, high resistance, short or harness connector for damage, corrosion, loose or broken terminals.
- REPAIR: Faulty wiring or connector.
- GO TO: Step 5.
|
| 5 |
- Final Procedure
- Perform a road test to verify repair.
-- Does the original DTC return? |
-- YES:
- CHECK: Engine/Motor Control Module -J623- harness connector for any damaged, pushed out pins.
- REPAIR: As necessary.
- If all electrical connections are OK:
- REPLACE: Engine/Motor Control Module -J623-.
- Clear the DTC's. Refer to: DIAGNOSTIC MODE 04 - ERASE DTC MEMORY
.
- Repair is complete. Generate Readiness Code. Refer to: READINESS CODE
.
- Return vehicle to Customer.
-- NO:
- Perform the diagnostic procedure for any DTC's.
- If no DTC's return, the repair is complete.
- Return vehicle to customer.
|