Assembly Mount, Adjusting

WARNING: This page is about a different car, the 2020 Volkswagen Arteon and 2019 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

-- Engine compartment battery: remove the battery tray -1-. Refer to BATTERY TRAY, REMOVING AND INSTALLING .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Luggage compartment battery: remove the air filter housing mount.

-- Support the engine in the installation position. Refer to ENGINE, SUPPORTING IN INSTALLATION POSITION .

-- Remove and replace the bolts -arrows- for the engine mount one after the other (if this was not already done when the engine was installed).

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the bolts loosely.

-- Slide the engine/transmission assembly with a pry bar until the following dimensions are set:

Fig 1: Identifying Distance And Dimension

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The clearance between the engine support -2- and the engine mount -1- must be -a- = 10 mm.
The casting edge on the engine support must be parallel to the engine mount support arm.
Dimension -b- = dimension -b-.

NOTE:

Distance -a- = 10 mm can also be checked with corresponding round stock.

-- Tighten the bolts on the engine mount.

-- Remove the bolts -arrows- for the transmission mount one after the other and replace them (if this was not already done when the engine was installed).

Fig 2: Identifying Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the bolts loosely.

-- Pay attention that on the transmission side the support arm and the transmission mount remain parallel.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Dimension -x- = dimension -x-.

-- Tighten the transmission mount bolts.

Tightening Specifications

Refer to OVERVIEW - ASSEMBLY MOUNTS
Refer to OVERVIEW - BATTERY .