Blind Spot Detection Control Module -J1086- / Blind Spot Detection Control Module 2 -J1087-, REMOVING AND INSTALLING: Installing
Install in the reverse order of removal while noting the following:
CAUTION:
The blind spot detection calibration normally occurs automatically.
-- Check the connector for damage, contact corrosion and water ingress, and service if necessary. Refer to WIRING HARNESSES AND CONNECTORS, REPAIRING .
| Nuts | Tightening Specification |
|---|---|
| Nut at the bracket | 3.5 Nm |
- Refer to OVERVIEW - BUMPER COVER .