Selector Lever Handle, Removing And Installing: Installing

Install in the reverse order of removal while noting the following:

The selector lever is in the "D" position.

NOTE:

It is possible that the button could be pressed into the handle. Never install the handle when the button is pressed in.

Fig 1: Identifying Caution For Button

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Move the button into the installation position. Refer to BUTTON IN HANDLE, MOVING INTO INSTALLATION POSITION .

A new handle is delivered with an assembly fastener. Pull out the retainer in the direction of -arrow- just before installing.

Fig 2: Identifying Direction To Pull Out Assembly Aid Just Prior To Installation

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the handle all the way onto the selector lever and lock it.

-- Push the sleeve downward to lock it.

-- Install the handle with a new clamp -arrow-.

Fig 3: Identifying Clamp

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Secure the clip using the Hose Clip Pliers: VAG1275A .

-- Connect the connector.

-- Press the button after installation.

NOTE:

If the button stays in the handle after being pressed, this means it was installed incorrectly. If this happens, remove the handle again and move the button into the installation position again. Refer to BUTTON IN HANDLE, MOVING INTO INSTALLATION POSITION . Install the handle again.

-- Clip in the selector lever handle cover.