ATF Level, Checking: Notes

WARNING: This page is about a different car, the 2021 Volkswagen Tiguan, 2020 Volkswagen Tiguan, 2019 Volkswagen Tiguan, 2018 Volkswagen Tiguan Limited, and 2018 Volkswagen Tiguan. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Used Oil Collection and Extraction Unit: SMN372500
Oil Filler: VAS6262A
Oil Filler - Adapter 2: VAS6262/2
Oil Filler - Adapter 6: VAS6262/6

Note the following information:

If ATF is filled, only use ATF that is available as a replacement part. Refer to the Parts Information.
The : VAS6262/6 must also be used for some fluid containers.

Fig 1: Adapter For Oil Filling 6 VAS 6262/6
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
It may be necessary to shorten the bleed pipe on the : VAS6262A .

Shorten the Bleed Pipe on the : VAS6262A as Follows:

Fig 2: Identifying Shortening Pipe On Adapter For Oil Filling VAS 6262 A

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Shorten the pipe to dimension -a- so that the bleed pipe on the : VAS6262A will not touch the bottom on some fluid containers.

Dimension -a- = 210 mm

NOTE:

Dimension -a- is measured starting from the shaft of the : VAS6262A (green surface in the magnified area).

-- Shorten the bleed pipe with the : VAS6056/2 , for example.

Fig 3: Cutting Pipe

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Requirements

The vehicle is level and all hoist mounts are the same height.
Noise insulation removed.
The Vehicle Diagnostic Tester is connected.
To begin working, the oil temperature should not be higher than 45 °C (113 °F).
Test temperature: 35 to 45 °C (95 to 113 °F)