Overview - Ignition System
WARNING: This page is about a different car, the 2021 Volkswagen Tiguan, 2020 Volkswagen Tiguan, 2019 Volkswagen Tiguan, and 2018 Volkswagen Tiguan. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 8 Nm +90° additional turn
- Always replace
- Tightening specifications affect the function of the knock sensor
- Knock Sensor 1 -G61-
- Removing and installing. Refer to Knock Sensor 1 -G61-, REMOVING AND INSTALLING .
- Spark Plug
- 30 Nm
- Remove and install using Spark Plug Removal Tool:3122B
- Replace the spark plugs. Refer to SPARK PLUGS, REPLACING .
- Spark Plug Connectors
- Assembling. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .
- Ignition Coil with Power Output Stage
- Ignition Coil 1 with Power Output Stage -N70-
- Ignition Coil 2 with Power Output Stage -N127-
- Ignition Coil 3 with Power Output Stage -N291-
- Ignition Coil 4 with Power Output Stage -N292-
- Removing and installing. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .
- Bolt
- 10 Nm
- Nut
- 10 Nm
- For the ground wire
- Dependent on the version
- Bolt
- 9 Nm
- Camshaft Position Sensor 3 -G300-
- Check the O-ring for damage before installing
- Removing and installing. Refer to Camshaft Position Sensor 3 -G300-, REMOVING AND INSTALLING .
- O-Ring
- Replace if damaged
- O-Ring
- Replace if damaged
- Camshaft Position Sensor -G40-
- Check the O-ring for damage before installing
- Removing and installing. Refer to Camshaft Position Sensor -G40-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- O-Ring
- Replace if damaged
- Engine Speed Sensor -G28-
- Check the O-ring for damage before installing
- Removing and installing. Refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Bolt
- 4 Nm + 45° additional turn