Additional Safety Precautions For Airbag Control Module

After every removal and installation of the Airbag Control Module -J234-, the Guided Function Inertial sensor basic setting  must be performed.

If the Airbag Control Module -J234- is replaced with a new part, the basic setting is performed when starting with the 0015 - Replace airbag control module  program.

If the Airbag Control Module -J234- was removed and the same one was reinstalled, perform an Initial sensor basic setting  .

-- Connect the Vehicle Diagnostic Tester.

-- Switch the ignition on.

-- Select and start the Diagnostic  operating mode.

-- Select the test plan  tab.

-- Select the Select individual test  button and select the following tree structure consecutively:

• Body
• Body-Assembly
• 01 - OBD-capable systems
• 15 - Airbag - Airbag Control Module -J234-
• 15 - Airbag, Functions
• 15 - Basic Setting
• 15 - Inertial Sensor Basic Setting

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.