Abs Control Module -J104-/ Abs Hydraulic Unit -N55-, Removing And Installing, LHD: Installing

Install in the reverse order of removal, while noting the following:

• The hydraulic unit is prefilled. Only remove the plugs on the hydraulic unit if the corresponding brake line is installed, so that sufficient filling and bleeding is guaranteed.

Condition

• When installing the hydraulic unit, the rubber bushings must not be pushed out of the bracket.

-- Position the brake lines using the Wrench - Assembly Tool :V.A.G 1410/8  in sequence -1- to -6-.

Fig 1: Brake Line Tightening Sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the brake lines in the sequence -1- to -6-.

-- Remove the Brake Pedal Actuator :V.A.G 1869/2  .

-- Refer to Hydraulic System, Bleeding .

If the ABS Control Module -J104- was replaced, then the test plan for replacing the control module must be performed.

-- Perform the "control module, replacing" function using the Vehicle diagnostic tester . Refer to Diagnostic Entries .

Continuation