Fuel Pump Circuit
- Remove fuel injection system relay. Check voltage at terminal No. 30. See Figure and Figure . If battery voltage does not exist, repair wiring between relay connector and battery.
- Connect jumper wire between terminals No. 30 and 87/2 of fuel injection system relay connector. Fuel pump should run. If fuel pump does not run, check wiring between pump and relay. Also check wiring between terminals No. 87/1 and 85 for continuity. Repair as necessary.
NOTE:
ECU terminal identifications are marked on unit or connector.
CAUTION:
Ignition must be off when connecting or disconnecting ECU connector.