Fault Conditions
WARNING: This page is about a different variant/trim than selected.
ECM-913F is stored in ECM if the electronic throttle module registers a fault in ECM.
No substitute values are used but some systems are disabled:
- Accelerator pedal is ignored when braking
- Cruise control cannot be activated
- RPM is limited using fuel shut off. Maximum permitted engine speed depends on accelerator pedal position
- Throttle unit follows pulse width modulation accelerator pedal signal directly and control signal via CAN is ignored
DTC can also cause uneven idle, jerking during engine braking and very poor throttle response.
NOTE:
Electronic Throttle System (ETS) warning lamp lights while ECM-911A is set.