Exposing the Sub-Frame
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.
Remove:
- the screw for the cable duct
- the screw for the ground lead.
Remove the screw for the front engine pad.
Fig 3: Identifying Oil Pipe For Steering Gear, Screw Clip For Steering Gear Return Line And Fuel Line For Engine Block Heater
Remove:
- the oil pipe for the steering gear from the snap fasteners along the sub-frame
- the screw clip for the steering gear return line
- the fuel line for the engine block heater, if applicable.
Remove the two screws holding the torque rod at the transmission.
Remove the anti-roll bar links from the anti-roll bar on both sides. Counterhold using a Torx wrench so that the ball joint boot is not damaged.