Specifications Index
SPECIFICATIONS INDEX - S60
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service Procedures | CLIMATE UNITS (2001-2009) | ||
| Service Specifications | AC COMPRESSOR | ||
| Torque | SUMMARY OF TIGHTENING TORQUES FOR SPECIFIC COMPONENTS | ||
| Axle Nut/Hub Nut | |||
| Torque | Step 1: 35 Nm Step 2: Angle tighten 90° |
||
| Battery | BATTERY SPECIFICATIONS (2001-2009) | ||
| Brakes | |||
| Bleeding Sequence | BRAKE BLEEDING | ||
| Disc Brakes | |||
| Service Specifications | WHEEL BRAKE - SPECIFICATIONS, MECHANICAL | ||
| Torque | TIGHTENING TORQUE | ||
| Charging | |||
| Generator | GENERATOR SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | ADJUSTMENTS | ||
| Drive Belt Routing | DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM (2001-2009) | ||
| Radiator Cap Pressure | 22 Psi (150 kPa) | ||
| Thermostat R & I | |||
| Turbo | REPLACING THE THERMOSTAT AND/OR ENGINE COOLANT TEMPERATURE SENSOR | ||
| Non-Turbo | THERMOSTAT / TEMPERATURE SENSOR, ENGINE COOLANT, REPLACING | ||
| Water Pump R & I | |||
| Turbo | COOLANT PUMP, REPLACING | ||
| Non-Turbo | REPLACING THE COOLANT PUMP | ||
| Engine Mechanical | |||
| Compression | |||
| Turbo | N/A | ||
| Non-Turbo | N/A | ||
| Oil Pressure @100 °C | |||
| Turbo | 14 psi (100 kPa) at 800 RPM and 49.8 psi (350 kPa) at 4000 RPM (Max. 70 psi (480 kPa) at 4000 RPM) | ||
| Non-Turbo | 14 psi (100 kPa) at 800 RPM and 49.8 psi (350 kPa) at 4000 RPM (Max. 70 psi (480 kPa) at 4000 RPM) | ||
| Overhaul | ENGINE - REMOVAL, REPLACEMENT AND INSTALLATION | ||
| Torque | |||
| Turbo | TIGHTENING TORQUE | ||
| Non-Turbo | TIGHTENING TORQUE | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | |||
| A/T | 33 ft.lb (45 N.m) and then turn an additional 65° | ||
| M/T | 33 ft.lb (45 N.m) and then turn an additional 65° | ||
| Fuel System | |||
| Pressure Specification | Relative Pressure: 380 kPa Absolute Pressure: 480 kPa |
||
| Fuel Pressure Test Procedure | |||
| Turbo | FUEL SYSTEM PRESSURE, CHECKING | ||
| Non-Turbo | FUEL SYSTEM PRESSURE, CHECKING | ||
| Fuel Filter R & I | |||
| Turbo | LEVEL SENSOR, REPLACING | ||
| Non-Turbo | LEVEL SENSOR, REPLACING | ||
| Ignition | |||
| Turbo | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Non-Turbo | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Spark Plug | |||
| Turbo | |||
| Volvo | kit # 8692071 | ||
| Gap | 0.7 - 0.8 mm | ||
| Torque | 30 Nm | ||
| Non-Turbo | |||
| Volvo | kit # 8642660 | ||
| Gap | 0.6 - 0.7 mm | ||
| Torque | 28 ± 3 Nm | ||
| Starting | |||
| Starter | STARTER MOTOR / CONTROL SOLENOID | ||
| Starter Motor Mounting Bolts Torque | 30 ft. lbs. (40 N.m) | ||
| Starter Motor Bracket Bolt Torque | 53 INCH lbs. (6 N.m). | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 103 ft.lb (140 N.m) | ||