Checking the wiring and component

HINT: The antenna cable is connected to the GPS antenna via a connector in the right-hand A-post. 

Fig 1: Identifying Ignition OFF

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Ignition off.

  Check the antenna cable between the carphone module connector G (gray) and connector E (terminal 1) in the right-hand A post. Check for an open-circuit according to Open circuit, permanent faults .

  Try replacing the antenna if no fault is found in the antenna cable.

  Remedy as necessary.

  Other information: 

  • The GPS antenna has an internal resistance of approximately 60 Ω
  • The resistance of the antenna cable between the carphone module and the connector in the right A-post, when measured using an ohmmeter, must be infinite between the signal cable and the shield or body ground
  • To access or replace the carphone module, see Phone module (PHM), replacing (-2004) 
  • To access and replace the antenna, see Antenna, carphone, replacing 
  • For information about signals and connectors, see Signal description, Phone module (PHM) .
  Fig 2: Identifying Phone Module (PHM) Connector E Terminals

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 3: Identifying Ohm Meter

  Courtesy of VOLVO CARS OF NORTH AMERICA.
  Fig 4: Connector F, Carphone Antenna (Brown Connector), Single Hirose GT5

  Courtesy of VOLVO CARS OF NORTH AMERICA.

Select "Continue" when the fault has been remedied. 

• Continue 

  Refer to Verification