Component Specifications
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2014 Volvo XC90, 2013 Volvo XC90, 2012 Volvo XC90, 2011 Volvo XC90, and 2010 Volvo XC90. However, it is still accessible from the selected car via links, so may be relevant.
The component specification gives the value of the component when the connector is disconnected. Where no value is given, it is not possible to measure a relevant value at the component.
Numbers in parenthesis indicate to which pin of the component the value corresponds.
| Designation | Type | Supply voltage | Value | Other |
| Air conditioning (A/C) relay | Mechanical relay | 12 V | 92 Ω ± 10% at 23 °C | |
| System relay Starter relay |
Mechanical relay | 12 V | 82Ω ± 10% at 23°C (coil) | |
| A/C pressure sensor | Absolute manifold absolute pressure (MAP) sensor | 5 V (#3) | Air conditioning (A/C) high pressure | |
| Brake light switch | Position switch | 12 V (#1) | The switch is closed when the pedal is depressed (terminals #1-#5) | |
| Intake pressure sensor | 5 V (#3) | |||
| Fuel temperature sensor | NTC resistor | 5 V (#3) | 2500 Ω ± 6% at 20 °C (#1-#2) | Integrated in the fuel pressure sensor |
| Fuel pressure sensor | Piezo resistive pressure sensor | 5 V (#3) | ||
| Engine cooling fan (FC) control module | - | 12 V (#2) | ||
| Evaporative emission system (EVAP) valve | Electromagnetic valve | 12 V (#1) | 20, 5 Ω ± 1, 5 Ω | |
| Actuator variable intake | Actuator, DC motor 1&2 | 12 V (#1) | 4 Ω | |
| Accelerator pedal (AP) position sensor | Electronic pedal sensor with two output signals, PWM and a linear analog signal | 12 V (#1) power supply digital position sensor 5 V (#6) Power supply analog position sensor |
||
| Throttle unit | Electronic throttle module (ETM) with two integrated potentiometers and a throttle motor | 5 V (#5) | 1.2Ω (#1-#2 motor winding) at normal operating temperature. | - |
| Injector | Electromagnetic injector valve | 12 V (#2) | Approximately 12 Ω at 20°C (terminal #1-#2) | |
| Camshaft sensor | Magneto-resistive sensor | 5 V (#1) | ||
| Knock sensor (KS) | Piezo electric component | Greater than 1 MΩ at 25 ± 10°C(#1-#2) | ||
| Oil level and oil temperature sensor | 5 V (#3) | |||
| Ignition coil | 12 v (#1) | Approximately 0.98 Ω (primary winding) | ||
| Preheating, front heated oxygen sensor | PTC resistor | 12 V (#3) | 2.18 - 2.68 Ω at 20 °C (#1-#2) | |
| Preheating, rear heated oxygen sensor (HO2S) | PTC resistor | 12 V (#1) | Approximately 13 Ω ± 1.3Ω (terminal #1-#2) | |
| Leak diagnostic unit | Consists of pump, electromagnetic valve and an internal heating element (PTC resistor) | 12 V (#4) | 118Ω (#1-#4 pump motor winding) 29.5Ω ± 10% (terminals #3-#4 Valve coil) 30Ω (#2-#4 Heating element) |
|
| Engine coolant temperature (ECT) sensor | NTC resistor | 5 V (#1) | 15040 Ω at -20 °C 2450 Ω at 20 °C 318 Ω at 80 °C (#1- #2) |
|
| Reset valve camshaft | Electromagnetic valve | 12 V (#1) | 7.4 Ω ± 0.5 Ω at 20 °C (#1-#2) | |
| Flywheel sensor | Induction sensor | - | 125, 5 Ω ± 17 Ω(#1-#2) | |
| Outside temperature sensor | NTC resistor | 5 V (#1) | 18702 Ω at -20 °C 6318 Ω at 0 °C 2424 Ω at 20 °C 1034 Ω at 40 °C (#1- #3) |
|
| Cam profile solenoid | Electromagnetic valve | 12 V (#1) | 8, 5 Ω ± 0, 5 Ω |