Checking The Components And Wiring

If short-circuiting or open circuit is obtained when reading out status of hall sensor, the cable harness between Power Operated Tailgate Module (POT) and hall sensor shall be checked. Also check the connector for Power Operated Tailgate Module (POT) for loose connection and oxidation.

If the cable harness is intact, replace Power Operated Tailgate Module (POT) and its hydraulic parts.

Checks after replacement 

Check that the latest software is in the module by downloading an upgrade for Power Operated Tailgate Module (POT).

Other information 

• see LOCATION OF COMPONENTS
• see CHECKING WIRING AND TERMINALS
• see POWER LIFTGATE MODULE
• see LOAD SENSOR, TAILGATE
• see LUGGAGE COMPARTMENT LID LIFT CYLINDER (2009-2010) or LUGGAGE COMPARTMENT LID LIFT CYLINDER (2008)

• Continue 

  Refer to VERIFICATION